Thursday, July 2, 2015

EJSS Micrometer Model

successfully re -created on Easy JavaScript Simulation EJSS!
can you read the reading of the Micrometer?
EJSS Micrometer Model
http://weelookang.blogspot.sg/2015/07/ejss-micrometer-model.html
run: Link1 , Link2
download: Link1, Link2
source: Link1, Link2

with hints, it is easy! what is 7.0 mm main scale and 0.87 mm on micrometer scale added together?
run: Link1 , Link2
download: Link1Link2
source: Link1Link2

check on the answers to see whether you got the answer correct. yes, it is 7.87 mm
run: Link1 , Link2
download: Link1Link2
source: Link1Link2

what if there were zero errors of +0.10 mm? the answer is 7.0 +0.97 - (0.10) = 7.87 mm
run: Link1 , Link2
download: Link1Link2
source: Link1Link2

what if there were zero errors of -15 mm? the answer is 7.0 +0.72 - (-0.15) = 7.87 mm
run: Link1 , Link2
download: Link1Link2
source: Link1Link2

Micrometer Model


Micrometers use the principle of a screw to amplify small distances that are too small to measure directly into large rotations of the screw that are big enough to read from a scale. The accuracy of a micrometer derives from the accuracy of the thread form that is at its heart. The basic operating principles of a micrometer are as follows:
The amount of rotation of an accurately made screw can be directly and precisely correlated to a certain amount of axial movement (and vice-versa), through the constant known as the screw's lead. A screw's lead is the distance it moves forward axially with one complete turn (360°). (In most threads [that is, in all single-start threads], lead and pitch refer to essentially the same concept.)
With an appropriate lead and major diameter of the screw, a given amount of axial movement will be amplified in the resulting circumferential movement.

The micrometer has most functional physical parts of a real micrometer.


Frame (Orange) The C-shaped body that holds the anvil and barrel in constant relation to each other. It is thick because it needs to minimize expansion, and contraction, which would distort the measurement. The frame is heavy and consequently has a high thermal mass, to prevent substantial heating up by the holding hand/fingers. has a text 0.01 mm for smallest division of instrument has a text 2 rounds = 100 = 1.00 mm to allow association to actual micrometer
Anvil (Gray) The shiny part that the spindle moves toward, and that the sample rests against.
Sleeve / barrel / stock (Yellow) The stationary round part with the linear scale on it. Sometimes vernier markings.
Lock nut / lock-ring / thimble lock (Blue) The knurled part (or lever) that one can tighten to hold the spindle stationary, such as when momentarily holding a measurement.
Screw (not seen) The heart of the micrometer It is inside the barrel.
Spindle (Dark Green) The shiny cylindrical part that the thimble causes to move toward the anvil.
Thimble (Green) The part that one's thumb turns. Graduated markings.
Ratchet (Teal) (not shown ) Device on end of handle that limits applied pressure by slipping at a calibrated torque.

Reference: